Devin's Crash Report #3

[Devin Manning 440]

I've never sent so many Crash reports in my entire life

5:31:40 PM Action: action_tl_extend
5:31:41 PM Action: action_tl_extend
5:31:43 PM Action: action_tl_extend
5:31:44 PM Action: action_tl_select
5:31:47 PM Action: action_tl_parent
5:31:59 PM Action: action_tl_select_single
5:32:09 PM Action: action_tl_extend
5:32:11 PM Action: action_tl_extend
5:32:12 PM Action: action_tl_select

Then it crashed

[KicksBrickster 4.3k]

Out of curiosity, did this happen after creating a schematic in 1.0.2?

[Devin Manning 440]

1 minute ago, KicksBrickster said:

Out of curiosity, did this happen after creating a schematic in 1.0.2?

Way after that, not directly after, I reloaded the project and no crashes are happening yet. It happened way after I imported a Rig (had to re-export the rigs I previously exported)

[KicksBrickster 4.3k]

5 minutes ago, Devin Manning said:

Way after that, not directly after, I reloaded the project and no crashes are happening yet. It happened way after I imported a Rig (had to re-export the rigs I previously exported)

I rest my case. Schematic + Rig = crash.

[Devin Manning 440]

1 minute ago, KicksBrickster said:

I rest my case. Schematic + Rig = crash.

This happened a full minute after I imported both

[KicksBrickster 4.3k]

Just now, Devin Manning said:

This happened a full minute after I imported both

Ok.

The program crashed on the action_tl_select event, after loading a schematic, then a rig. I tested this a few hours ago. Your report proves it.