Jump to content

How to apply textures to the Mob Pack villager model


Message added by TopicLocker3000

This topic was automatically locked after 6 months of inactivity. If you are the topic owner, please contact a moderator to have it unlocked.

Recommended Posts

NOTE: This tutorial only works with the Mob Pack villager model. This does not have compatibility with any other rig.

Some of you guys might have this problem with the villager model: The textures replace the base villager texture.

You might've used a method which you have 4 villager models with different textures: base, biome type, profession, and level. This method is a LITERAL PAIN TO USE BECAUSE YOU ANIMATE IT AND THE ANIMATION WOULD HAVE TO BE APPLIED ON THE REST OF THE MODELS TO STAY CONSISTENT WITH THE VILLAGER THAT YOU ARE ANIMATING!!!

Want to know how to apply textures to the villager model? Then use this method.

Here are 7 steps on how to apply textures on to villager models. Make sure to use a painting application that supports transparency.

  1. Start with the base texture. It's a kickstarter.
  2. Apply a biome type to the texture. Make sure it's applied as a new layer.
  3. Apply profession. It also has to be a new layer.
  4. Apply profession level. That's also a new layer.
  5. Save it as a new texture.
  6. Uncheck texture in the hierarchy tab for the mouth properties.
  7. Change texture in the texture tab for animation. Do not change the texture in the library tab for project properties.

For the zombie villager texture, it's the same steps.

Edited by tutibrave
Link to post
Share on other sites

Guest
This topic is now closed to further replies.
  • Recently Browsing   0 members

    No registered users viewing this page.

  • Create New...