Jump to content

Separate Inherited bends in ModelBench

PikaGamerPro

By PikaGamerPro,
in Suggestions

Share
TopicLocker3000
Message added by TopicLocker3000

This topic was automatically locked after 6 months of inactivity. If you are the topic owner, please contact a moderator to have it unlocked.

Recommended Posts

PikaGamerPro

PikaGamerPro 23

Posted
Posted

I have been getting used to ModelBench for sometime now and I am a couple of steps away from mastering my skills. I have 1 Suggestion that can definitely make ModelBench Rigs more customizable. the X,Y, and Z tab getting their own "Inherit bend" Option would be good instead of the three sharing the inherit bend option :v I CAN'T MAKE BELTS :<

Link to post
Share on other sites
Guest
This topic is now closed to further replies.
Share
Go to topic listing

  • Recently Browsing   0 members

    No registered users viewing this page.

  • Create New...