Jump to content
  • 0

World Import not fully importing


Message added by TopicLocker3000

This topic was automatically locked after 6 months of inactivity. If you are the topic owner, please contact a moderator to have it unlocked.

Question

4 answers to this question

Recommended Posts

  • 0
On 2/18/2020 at 10:13 PM, MojangYang said:

It should work fine if you selected the section properly. make sure the selected Y (height) of the selection area is high enough to capture your entire set.

It captures the height mostly okay, but then cuts of a little of the Y axis by like a block or two and the X and Z axis by a lot

 

Link to post
Share on other sites

  • 0
20 minutes ago, InnocenTraitor said:

It captures the height mostly okay, but then cuts of a little of the Y axis by like a block or two and the X and Z axis by a lot

 

weird.

it's normal to cut off a few blocks though. You shouldn't loose more than 2 blocks.

Link to post
Share on other sites

Guest
This topic is now closed to further replies.
  • Recently Browsing   0 members

    No registered users viewing this page.

  • Create New...