Jump to content

Schematic Auto-Iluminator and Door-Creator.


Message added by TopicLocker3000

This topic was automatically locked after 6 months of inactivity. If you are the topic owner, please contact a moderator to have it unlocked.

Recommended Posts

Make a Toggler in Schematic Settings to Automaticly adds Lights in the Schematic like childs of Schematics, so we don't need to put a lot of Lights in all the Schematics.

 

Also, can make this same thing for Chests and Doors? Automaticly replaces Doors, Chests and Stuff in the schematic to the Special Block version so we can open and close.

Link to post
Share on other sites

Been suggested before, the problem is that people who prefer to light up areas on their own don't like this method as it just makes each and every single schematic run the framerates down lower than need be. Imagine a map where torches are spammed all over, there would be a light on every single torch. Do you think your computer could handle that amount of lights in one scene?

 

Though the doors variant sounds nice. But this can just be done using the built-in schematic loader and filtering out all the doors.

Link to post
Share on other sites

@ÜberKiller

 

I know about the whole Schematic Loader and filtering out stuff, but the thing is, the Schematic Importer thing doesn't work for me, it always pops up as an error. I could try again and post a picture of it if you would like, but I've already reported that problem to David, so check one of my topics

Link to post
Share on other sites

Guest
This topic is now closed to further replies.
  • Recently Browsing   0 members

    No registered users viewing this page.

  • Create New...